Start The Machine; Stop The Machine; Maintenance; Nozzle Maintenance - GreenWorks GDC40 Manual

EN
8.4

START THE MACHINE

Do not operate without the water supply connected.
Before you start the machine:
1. Turn the water supply on.
2. Pull the gun trigger (10) to release air pressure.
3. If a stable stream of water come into view, release the
gun trigger (10).
1. Set the power switch to the "ON" ( | ) position.
2. Pull the gun trigger (10).
8.5

STOP THE MACHINE

1. Release the gun trigger (10).
2. Set the power switch to the "OFF" (O) position.
If you do not use the machine：
• Stop the machine.
• Turn the water supply off.
• Remove the battery pack.
• Pull the gun trigger (10) to release the remaining
pressure from the machine.
• Lock the trigger safety button (14).
9

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
CAUTION
WARNING
CAUTION
English
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
9.1

NOZZLE MAINTENANCE

20
If there is too much pump pressure, the nozzle can become
clogged, you can feel a pulsing sensation while you pull the
gun trigger.
9.1.1 REMOVE THE NOZZLE
1. Remove the nozzle (19) from the spary wand (8).
9.1.2 CLEAN THE NOZZLE
1. Use a straight paper clip or cleaning tool (20) to clean the
spray tip.
2. Flush and clean the unwanted materials out of the nozzle
(19) with the garden hose (15).
3. Install the clean nozzle (19) to the spray wand (8).
10 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.
10.1

MOVE THE MACHINE

• Point the spray wand in a safe direction.
10
CAUTION
WARNING
19
WARNING