6.4
Working position
The burner is designed to operate only in the po-
sitions 1, and 3 (Fig. 6).
Installation 1 is preferable, as it is the only one that
allows performing maintenance operations as de-
WARNING
scribed in this manual. Installations 2, 3 and 4 al-
low working operations but not maintenance with
hooking to the boiler.
1
D4618
6.5
Boiler fixing
E9050
Installation
2
1
Fig. 7
5
1
9
Any other position could compromise the correct
operation of the appliance. Installation 5 is forbid-
den for safety reasons.
DANGER
3
Provide an adequate lifting system of the burner.
Put on the flange 1)(Fig. 7) the screw and two nuts.
Fix the flange 1)(Fig. 8) to the boiler door 4) using screws 2)
and (if necessary) the nuts 3) interposing the insulating gas-
ket 5).
The seal between burner and boiler must be
airtight.
WARNING
4
2
GB
4
5
3
E9094
Fig. 6
Fig. 8
20166849