Introduction; Features; Getting Started - Phonic SupraCurve A6600 User Manual

INTRODUCTION / FEATURES / GET TING STARTED

INTRODUCTION

Congratulations on your purchase of the A6600
SUPERCURVE, a dual 31-band graphic equalizer. In
order to get the best performance from your A6600
SUPERCURVE, please read this user' s manual
carefully and keep it for future reference.

FEATURES

Extremely low noise, high-quality performance
●
30mm VR for precise adjustment
●
Switchable boost/cut range: 6dB and 12dB
●
EQ IN/OUT switch
●
Center-dented sliders
●
Illuminated buttons and faders
●
+/-15dB input gain range for easy level matching
●
8-segment LED input level display with CLIP
●
warning
Dual variable 15Hz to 400Hz LOW CUT fi lter and
●
2.5KHz to 30KHz HIGH CUT fi lter
Auto relay-controlled bypass
●
Balanced inputs and outputs
●
1/4" TRS and XLR connectors
●
Shielded toroidal power transformer for low noise
●
interference
Page 4

GETTING STARTED

1 Check the AC voltage before connecting the plug.
The unit must be properly grounded to avoid electrical
shock to the operator. Choose the main supply for the
sound system with care, and do not share sockets or
grounding with light dimmers.
2 Separate audio cables from dimmer wiring, using
balanced lines wherever possible. If feasible, cross
audio and lighting cables at right angles to minimize
the possibility of interference. Keep unbalanced
cables as short as possible.
3 Check your cables regularly and label each end for
easy identifi cation.
4 Before switching on the main power, set the input
level control to its minimum setting. Doing so will
prevent excessive noise caused by bad level
adjustment, faulty wiring, defective cables, or bad
connections.
5 Always turn the unit on before turning on the
power amplifi er; always turn it off after turning off the
amplifi er.
6 Always turn off the main power before connecting or
disconnecting the unit.
7 Never use solvents to clean the unit. Clean the unit
with a soft, dry cloth.
A6600 USER'S MANUAL
PHONIC CORPORATION