Sunbeam 32610047 Owner's Manual page 4

Tip: It is not necessary to have a full tank of water for the Steamer to
generate steam. For best results, just make sure the water tank is at least
half full.
4. Close the water-fill cover and refit the water tank into the stand. Pull on
the reservoir to ensure it is fully locked in position.
Note: If you need to add water while steaming, unplug the steamer,
wait until it cools and follow the above steps. If a cloud vibrating noise
is heard, then the water level is low and needs to be refilled.
USING YOUR STEAMER VERTICALLY
You can use your Steamer in the vertical position to press with steam
hanging garments and drapes.
1. With the water tank filled, attach steam guard accessory to help protect
your fingers from burning (refer to ATTACHING AND REMOVING
STEAM GUARD ACCESSORY).
2. Hang your garment to be steamed on a clean, rust-free hanger.
3. State 1: The Steamer is unplugged (off): No heat function and no light
is shown.
State 2: When the Steamer is plugged in, the indicator light will initially
flash red to indicate that the Steamer is heating up.
State 3: The indicator light will turn solid blue to indicate the the
Steamer has finished heating and is now in the Low steam mode.
State 4: Press the Setting button, and the indicator light will turn red,
indicating that the Steamer is now in High steam mode
After this, pressing the Setting button will cycle the Steamer back and
forth between the Low and High steam settings.
Warning: Care should be taken to arrange the cord so that it cannot
be pulled or tripped over. Always make sure you can move freely
without getting tangled with the cord.
Note: You can press the Set button whenever you wish to switch the
steam level between Low and High.
Caution: Burns could occur from touching hot parts, hot water, or
steam. Use care when you turn a steam appliance upside down – there
may be hot water in the reservoir.
4. Hold your Steamer by the handle in vertical position with the head
pointing toward the fabric and away from you and your body.
Warning: Steam is hot. Always point steamer exit away from yourself,
other persons, pets, plants and walls. Never steam clothes while they
are being worn.
English - 5
5. With your free hand, pull the fabric tight and press the trigger switch as
you move the Steamer over the fabric.
6. You can use the trigger two ways:
a. Press the switch to generate steam and release it to pause the steam.
b. To get continuous steam, you can press the trigger switch and slide it
down to the lock-down position. To release, slide it up
7. Touch the fabric lightly with the Steam Head, moving it in a downward
motion, beginning at the top of the garment and moving downward.
Repeat until fabric is wrinkle-free.
Tip: For more difficult wrinkles, try steaming from the underside of the
fabric.
8. When finished, unplug from electrical outlet and place steamer on a flat
surface.
9. Wait until Steamer has cooled and empty water tank.
Note: Always unplug the Steamer when not in use.
AUTO-OFF FEATURE
After 8 minutes of operation, the Steamer switches to the Auto-off mode
and stops generating steam. The red Heating indicator light blinks to
indicate that the Auto-off mode has been activated. To restart the steamer,
press the I /II button or press the trigger
STEAMING HORIZONTALLY
You can also use your Steamer as an iron to refresh sheets, pillows, mattress,
sofas and more.
1. After the water tank is filled, make sure there is no residual water inside
the center water tank cavity. Attach the water tank to the Steamer.
Attach the steam guard accessory and follow step 3 under USING YOUR
STEAMER VERTICALLY.
2. Once the Steamer has reached set temperature, press trigger switch
and in a horizontal position, move the steamer continuously over the
fabric being steamed. For bed bug and dust mite treatment, follow the
NOTES in steps 3 and 7 under USING YOUR STEAMER VERTICALLY.
Caution: The heated press bar gets hot, do not touch.
3. Once you finish, release the trigger and unplug the unit. Wait for unit
to cool completely before emptying the water tank or removing the
fabric brush.
English - 6