Shot Of Steam; Care And Cleaning; Steaming Tips - Sunbeam 32610047 Owner's Manual

SHOT OF STEAM

Shot of Steam ® Feature provides an extra burst of steam for deep penetration
of stubborn wrinkles.
To use the SHOT OF STEAM FEATURE: Press the trigger button twice within
®
1 second each time you would like an extra burst of steam.
The SHOT OF STEAM ® feature may be used continuously in approximately 3
second intervals.

STEAMING TIPS

Improper use of the Steamer can cause property damage due to the
•
steam. Always read the instructions in this manual before using your
Steamer.
• Do not operate the Steamer with an empty water tank. To add water
during operation, turn steamer off, wait for it to cool down then remove
water tank and refill.
• Always read the fabric care labels to help determine fabric type to be
steamed. If unsure of fabric's fiber, test a small hidden area, such as an
inside seam or hem, before steaming.
• For more difficult wrinkles, try steaming from the underside of the fabric.
• When steaming, touching fabric lightly with the steam nozzle can help in
wrinkle removal. It is important to make contact with the garment and/
or fabric.
• Heavier fabrics require more steam.
• Only use water in the unit. Do not add cleaning solutions, scented
perfumes, oils or any other chemicals to the water that can cause
damage to the appliance.
• Do not use steam directly against wall or doors.
• When hanging garment on a door while steaming, be careful not to
damage the door with steam.
• After use, empty water tank by turning it upside down to ensure all
water empties out and avoid leaks.
• When steaming, move the steamer continuously over the item being
pressed. Do not keep steamer over an area for any period of time to
avoid damage to the fabric.
English - 7

CARE AND CLEANING

CLEANING
1. Make sure unit is off, unplugged and allow it to cool completely before
cleaning.
2. If there is water in the water tank, remove the tank and turn it upside
down to ensure all the water empties out.
3. Wipe exterior surfaces with a soft, damp cloth. Dry thoroughly.
Warning: Never immerse steamer, cord or plug in water or any other
liquid.
• Do not use abrasive cleaners or scouring pads that can scratch
the surface.
• Do not place in the dishwasher.
CLEANING WITH VINEGAR AND WATER
It is recommended to clean your Steamer every two months to reduce
mineral buildup that can affect the performance of your unit.
1. Turn off the unit and let it cool completely.
2. Remove water tank and make sure it is empty.
3. Fill water tank with a solution of 50% white vinegar and 50% water up
to the max level.
4. Plug unit into electrical outlet and press trigger to run a full steaming
cycle.
5. Once steaming is finished, fill with clean water and repeat process until
the vinegar odor is eliminated.
STORAGE
Store the unit in upright position, in a clean dry place with a flat, sturdy
surface. Make sure the water tank is empty. If not, remove it and turn it
upside down to ensure all the water empties out and avoid leaks.
English - 8