Support Assembly - Dell Studio One 19/1909 Service Manual

Back to Contents Page
Support Assembly
Dell Studio One 19/1909 Service Manual
Removing the Support Assembly
Replacing the Support Assembly
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
surface (such as the computer stand).
Removing the Support Assembly
1. Follow the instructions in
2. Remove the hard drive (see
3. Remove the power supply unit (see
4. Remove the optical drive (see
5. Remove the side I/O panel (see
6. Remove the inverter (see
7. Remove the system board (see
8. Remove the fourteen screws that secure the support assembly to the LCD panel.
1 screws (14)
9. Disconnect the following cables from the LCD panel:
LVDS cable from LVDS connector
l
touch pad cable from the touch pad connector
l
touch panel cable from the touch panel module
l
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
Before You Begin.
Removing the Hard Drive).
Removing the Power Supply
Removing the Optical
Removing the Side I/O
Removing the Inverter).
Removing the System
2

support assembly

UserManuals.info
Unit).
Drive).
Panel).
Board).