Trouble Shooting - Technika TFL7W User Manual

TROUBLE SHOOTING

Problem
Programmes
do not start after
the loading door
is closed
Programme
cannot be started
or selected
Water inside
the product
The product does
not take water in
The product does
not drain water
Product vibrates
or makes noise
36
Possible Cause
a) Start / Pause / Cancel
button is not pressed.
b) It may be difficult to close
the loading door in case
of excessive loading.
a) The product has switched to
self protection mode due to a
supply problem (line voltage,
water pressure, etc.)
a) Some water has remained in the
product due to the quality control
processes in the production.
a) Tap is turned off
b) Water inlet hose is bent.
c) Water inlet filter is clogged.
d) Loading door is not closed.
a) Water drain hose is
clogged or twisted.
b) Pump filter is clogged.
a) Product is standing unbalanced.
b) A hard substance has
entered into the pump filter.
c) Transportation safety
bolts are not removed.
d) Laundry quantity in
the product is too little.
e) Excessive laundry is
loaded in the product.
f) Product is leaning on a rigid item.
Try
a) Press Start / Pause / Cancel button.
b) Reduce the amount of laundry
and make sure that the loading
door is closed properly.
a) To cancel the programme, turn
the Programme Selection knob to
select another programme. Previous
programme will be cancelled (see.
"Cancellation of programme").
a) This is not a failure; water is
not harmful to the product.
a) Turn on the taps.
b) Flatten the hose.
c) Clean the filter.
d) Close the door.
a) Clean or flatten the hose.
b) Clean the pump filter.
a) Stable the product by
adjusting the feet.
b) Clean the pump filter.
c) Remove the transportation
safety bolts.
d) Add more laundry to the product.
e) Take out some of the laundry from
the product or distribute the load by
hand to balance it homogeneously
in the product.
f) Make sure that the product
is not leaning on anything.