Table of Contents
Advertisement
Tri-Grip Clamps
The side arms are shipped with the tri-grip clamps already
mounted. In the event that the clamps need to be removed,
note that they are mounted to the side arms by a single
setscrew on the bottom of the side arm and that a
sequence of assembly is followed.
1.
Slide each tri-grip clamp into a hole in a side arm.
The clamp closest to the body should reach back-
ward from the unit the next closest clamp should
reach forward, and so on until all clamps are
installed.
2.
Position each clamp so that the rear of its shaft
extends slightly from the side arm and so that the
clamp will hold items at the desired angle. Secure
each clamp to the side arm by tightening the
setscrew on the bottom of the side arm. For those
applications requiring the clamps to be positioned
vertically, rotate the side arms 90º.
Installing the Optional Utility Tray
1.
A utility tray is available as an option and can be
used to increase the capacity of the shaker. To
install the utility tray, center the tray over the shak-
er body. Line up the holes on the mounting brack-
ets of the tray with the holes located on the top of
the side arms.
2.
Screw in the mounting bolts using a 1/4-inch Allen
wrench. Tighten securely.
3.
Check for tightness periodically.
4.
Carefully position vessels on the tray. Be careful
not to fill vessels to levels where spilling might
occur during shaking action.
U
I
NPACKING AND
NSTALLATION
9
Advertisement
Table of Contents
