Lantronix SM24TBT2DPA Install Manual page 19

Lantronix
Power Supply Electrical Specification
Output requirements: The power supply has +54.5V single output. The table below specifies its output
parameters.
Parameter
Voltage
Minimum Current
Maximum Current
Line Regulation
Load Regulation
Overshoot
Undershoot
Maximum continuous output power: Maximum continuous output power is not to exceed 920W.
Over-voltage protection (OVP) :
the +54.5V output.
OVP
Over-current protection (OCP) : The outputs should be over-current protected. The output should never exceed
21.84A@920W on the +54.5V output.
920W OCP
Power Supply LED Indication: Each module shall provide two LED status indicators on the front panel.
LED location
Color=GREEN
Frequency
Color=RED
Frequency
Note: "@1+1" the mean is 1+1 redundant mode condition.
33737 Rev. L
+54.5V Output
+54.5VDC
0A
16.88A
+/-1%
+/-3%
3%
3%
The outputs should be over-voltage protected. The output should never exceed +60V on
Minimum
+57.3V
Minimum
18.56A
AC OK
Right side of front panel.
AC on line.
1Hz
Loss AC. @1+1
1Hz
DC OK and AC OK LED indication location diagram
https://www.lantronix.com/
SM24TBT2DPA Install Guide
Typical
+58.65V
Typical
20.256A
DC OK
Left side of front panel.
DC is good.
1Hz
DC is failing. @1+1
1Hz
Maximum
+60V
Maximum
+21.84A
Page 19 of 38