Redline robored G2 Instruction Manual page 23

Please turn on the power
8
switch.
Please poke the surface
9
of the laser sensor.
Please clean the laser
10
sensor lens on top.
Please click the start
11
button again.
Dust fan fault. Please
12
contact after-sale service
Front wheel fault, pis
13
restart
Communication error,
14
please restart or contact
after-sale service
Battery fault， please
15
contact after-sale service
The robot is trapped.
Please move to a new
16
place
Please put the robot on
17
the charging station
Note: If above solution don't work， please try as below:
1. Switch off the robot and restart it.
2. If restarting robot doesn't work, pis send the robot to after-sales service center.
Power switch turn off during
charging
The laser sensor locked or
shaded by something
Something stick or shaded on
the laser sensor
Button locked
Robot Fault
Robot Fault
Robot Fault
Battery temperature abnor-
mal
The robot trapped by some-
thing
Battery too low to find the
charge station
16
Please turn on the power switch
Please clean the laser sensor
Please clean the laser sensor and start-up robot
in a safe place
Please click the start button again
Please Turn off the power switch and restart try
again. Please contact the after-service if no still
no working.
Please Turn off the power switch and restart try
again. Please contact the after-service if no still
no working.
Please Turn off the power switch and restart try
again. Please contact the after-service if no still
no working.
Please restart try again after the battery tempera-
ture recover. Please contact the after-service if no
still no working.
Please move robot to a new place and restart it.
Please place robot on the charge station for
charging.