Battery Charging - Redline robored G2 Instruction Manual

Product Operation

Battery Charging

1. Charging Station Placement Place charging station
against the wall, and remove obstacles about 1 meter
at two sides and 2 meters in front of the station as
show in the right figure.
Note: îf robot is powered off, then switch on the robot
firstly before charging.
2. Charge the robot in either way as shown below:
a. plug one end of the adapter into the robot and the other
end into the power socket.
b. Press "Re-charge" button on APP to operate the robot
looking for the charging station automatically.
c. Press the K ®H button twice in a short time, robot will
go back to charging station for charging.
Note:
A. In standby or working status, the robot will looks for
charging docking automatically when battery capacity is
low.
B. During the process of looking for charging station, if robot
run out of power before arriving the charging station, it will
broadcast voice "Battery low, robot is shutting down" and
shut down within twenty minutes.
C. When battery in working status, you should "Pause" it
first， let it "Standby"， then "Re-charge".
In Order to Extend Battery Life
A. Please charge the robot up to 12 hours in first
charging.
B. Charge the robot as soon as possible when battery
capacity is low.
C. The robot will return to the charging station auto-
matically when accomplish cleaning or battery
capacity is low.
D. When you will not use the robot for some time,
please fully charge the battery firstly, then switch off
the robot and keep it in a cool but dry place.
E. If the robot has been put aside over 3 months,
please charge the robot for 12 hours firstly before use
it for cleaning.
7