Table of Contents
Advertisement
Speaker Connections
Connect speaker wires
observing polarity. The
minimum impedance load
for the
amplifiers is 2 ohms
stereo and 4 ohms bridged.
Use of loads lower than these
is not recommended and may
cause amplifier damage. The
amplifiers can be wired for
stereo,
bridged or stereo/
bridged simultaneous
operation.
Input Signal Connections
Low Level Input (RCA)
Low level (RCA) input signal is preferred for best performance. Typical trunk-
mount amplifier installations require a 17-20 foot RCA cable. Most trucks
and under-seat applications require a 6-9 foot RCA cable. Using twisted pair
construction RCA cables will minimize noise.
Low-Level Input
(RCA)
Note: Do not use both low and high level inputs
at the same time - connect only one or the other.
8
INSTALLATION
Amplifier Connections
2 Speakers (stereo)
Typical Stereo Wiring
(2 ohms minimum)
High Level Input
(Speaker Wire)
High level inputs should only
be used when RCA outputs are
not available from the head unit.
Connect the head unit speaker
outputs to the high level input
connector as shown below. The
black wire (signal reference
ground) may or may not require a
connection to chassis ground
- depending on your particular
installation.
Speakers (bridged)
Typical Bridged Wiring
(4 ohms minimum)
L
R
Advertisement
Table of Contents
