Dual DA560D Installation & Owner's Manual
Compact series mobile power amplifiers 1200 watts 5 channel
Hide thumbs
Also See for DA560D:
- Installation & owner's manual (13 pages) ,
- Installation & owner's manual (13 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Dual DA560D
Summary of Contents for Dual DA560D
- Page 1 DA560D COMPACT SERIES INSTALLATION / OWNER'S MANUAL Mobile Power Amplifiers...
- Page 2 INSTALLATION Preparation Please read entire manual before installation. Due to the technical nature of amplifiers, it is highly recommended that your Dual amplifier is installed by a professional installer or an authorized dealer. Before You Start • Disconnect negative battery terminal. (consult a qualified technician for instructions) •...
-
Page 3: Connection Descriptions
INSTALLATION Connection Descriptions NOTE: Be sure to follow specific instructions included with your amplifier installation kit (not included with this amplifier). The information below should be used as a general guideline only. Power Wire (+12V) • Disconnect negative battery terminal before proceeding. Consult a qualified technician for instructions if you are unsure. - Page 4 INSTALLATION Audio Inputs and Controls DA560D High Pass Filter Low Pass Filter Crossover Mode Bass Boost Gain...
-
Page 5: Power And Speaker Connections
INSTALLATION Power and Speaker Connections DA560D Ground Connection Speaker Connections Fuse +12VDC Battery Connection... -
Page 6: Typical Wire Routing
When replacing fuses, make sure new fuse size listed below or larger. Make sure to use is the correct type and amperage. Using an the same size power and ground wire. incorrect fuse could damage the amplifier. DA560D 4 Ga DA560D 40A x 1... -
Page 7: Amplifier Connections
Speaker Connections Connect speaker wires observing polarity. The minimum impedance load for the DA560D is 2 ohms stereo and 2 ohms mono. Use of loads lower than these is not recommended and may cause amplifier damage. CHANNELS 1 & 2 CHANNELS 3 &... -
Page 8: Configuration/Setup
INSTALLATION Configuration/Setup Input level Control The input level control (gain) is used to obtain the best possible match between the head unit audio output and the amplifier input. Begin by turning the input level control fully counterclockwise. Next, turn up the head unit volume control around 3/4 of the way up. -
Page 9: Troubleshooting
INSTALLATION Troubleshooting Problem Cause Action +12V wire not connected or incorrect Check connections for proper voltage voltage. REM wire not connected or Unit will not turn on (11~16VDC) incorrect voltage (no power LED indicator) GND wire not connected Check connection to ground Fuse(s) blown Replace fuse(s) Speaker wires not connected... -
Page 10: Specifications
INSTALLATION Specifications DA560D Channels 1,2,3 and 4 Power Output (14.4VDC, 20Hz ~ 20kHz): •60 Watts RMS x 4 channels @ 4 Ohms •85 Watts RMS x 4 channels @ 2 Ohms •200 Watts RMS x 2 channels @ 4 0hms (bridged) -
Page 11: One-Year Limited Warranty
A slight adjustment of any custom controls may save you a service Dual Electronics Corp. warrants this product to the original purchaser to be free from call. defects in material and workmanship for a period of one year from the date of the 2. - Page 12 Dual Electronics Corp. Toll Free: 1-866-382-5476 Monday-Friday, 9AM-5PM, EST www.dualav.com ©2014 Dual Electronics Corp. NSA1113-V01...