Page 1
Waterproofing: What to Know English / 简体中文 / 日本語...
Page 3
1. Before use, make sure that the USB lock cover, battery lock cover, and the battery’s rubber seal are intact and functioning properly. If there are any issues or you are unsure, please contact Insta360 Support. Note: Strong vibrations, shock, or pressure to the camera may compromise the waterproofing performance.
Page 4
2. When using in or around water, dirt or sand, make sure to properly close the battery lock cover and USB lock cover (the orange indication marks should not be visible and you should hear a clicking sound when they are closed correctly). The orange indication marks...
Page 5
3. When using X3 in water, please lock the touch screen to avoid accidental button presses. 4. Always ensure that the battery lock cover and USB lock cover are free from any foreign objects (e.g. dirt, hair, etc) before closing. If necessary, clean with a soft, dust-free cloth.
Page 6
5. To close the USB lock cover: ❶ Press the notch on the USB lock cover into the shaft. ❷ Press the bottom of the cover into place, and slide the lock buckle down until it clicks. ❸ When the orange indication mark is covered, this indicates that the USB lock cover has been properly closed.
Page 7
6. Insert a micro SD card (Its label should face outwards towards the touch screen.) Supported micro SD cards: Please use exFAT formatted microSD cards with the UHS-I bus interface and Video Speed Class V30 rating (exactly this class, neither higher or lower) to ensure normal recording. The maximum supported storage space is 1TB.
Page 8
360 stitching and image quality underwater will be affected due to light refraction underwater. 9. After every use in water, clean and dry X3 with a soft cloth. Failure to properly dry X3 might result in damage to the camera.
Page 9
10. After every use in water, for the best audio performance, gently shake and dry X3 with a soft cloth, and place it in dry, well- ventilated environment for 24 hours to ensure the microphone and speaker holes are clean and dry. Do not use a hair dryer to blow into the holes, as this could damage the internal waterproof membranes.
Page 11
简体中文 1、使用前,请检查 USB 盖、电池卡扣、防水胶圈是否完整,如 发现破损,请联系官方技术支持( https://www.insta360.com/ support)。对相机施加剧烈的震动、冲击或压力可能会影响相 机的防水性能。...
Page 12
2、当相机在水下、近水、潮湿、多尘、多沙等环境中使用时, 请确保电池盖和 USB 盖已完全锁紧(橙色标识显示不可见), 否则将影响整机的防水性能。 橙色标识...
Page 13
3、当相机在水下使用时,请使用锁屏功能,将屏幕锁定,以防 误触屏。 4、关闭电池盖和 USB 盖之前,确保电池盖防水胶圈和 USB 盖 无灰尘和异物。如有需要,用无尘布清洁密封件。 USB 盖 防水胶圈...
Page 14
5、USB 盖锁合步骤:❶ 将 USB 盖对应嵌合至转轴;❷ 按压 USB 盖底部直至发出咔哒声 ; ❸ 拨钮处的橙色标识显示不可见时, 表明 USB 盖已完全锁紧。 ❶ ( USB 盖) ❷ ❸...
Need help?
Do you have a question about the X3 and is the answer not in the manual?
Questions and answers