Advertisement
Step #4) First discharge the CRT, it has high voltage. Be careful. Put a flat
head screw driver underneath the anode lead cap so it is touching the metal
part.
And get another screwdriver and cross it with the flat head used and touch
the metal frame with it. After a minute take the Anode lead Cap off or unplug
it from the driver board of the CRT.
Remove the
Anode Lead Cap
squeezing the
metal pins in
with a flat head
screwdriver.
Step #5) Unplug the Neck Board then Unscrew the CRT from the frame
(keep fasteners for re-installation). Push the CRT out of the frame and then
Unplug the Yoke & Unscrew the Ground from the Yoke.
Unscrew the
Remove
four screws
the
holding the
Neck
CRT. Keep
Board
these.
Unplug the Yoke and the
Unscrew the Yoke Ground
from the Frame.
M20A03-ML080QT8520MS
4
Advertisement
