Electrolux ESL2500RO User Manual page 15

9.1 What to do if...
With some problems programme indicators flash intermittently indicating a
malfunction.
Problem
You cannot activate the
appliance.
The programme does
not start.
The appliance does not
drain the water.
The appliance does not
fill with water and an in‐
termittent acoustic signal
sounds for approximate‐
ly 30 seconds.
The required tempera‐
ture is not reached.
The anti-flood device is
on and an intermittent
acoustic signal sounds
for approximately 30
seconds.
Technical malfunction of
the appliance.
Once you have checked the appliance,
set and start the programme again. If the
problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
The display Possible solution
shows...
- • Make sure that the mains plug is con‐
nected to the mains socket.
• Make sure that there is no damaged
fuse in the fuse box.
- • Make sure that the appliance door is
closed.
• Press the start button.
• If the delay start is set, cancel the set‐
ting or wait for the end of the count‐
down.
- • Make sure that the drain hose is cor‐
rectly connected.
• Make sure that the filters in the appli‐
ance are clean.
• Make sure that the kitchen sink drains
correctly.
E1 • Make sure that the water tap is open.
• Make sure that the pressure of the wa‐
ter supply is not too low. For this infor‐
mation, contact your local water authori‐
ty.
• Make sure that the water tap is not
clogged.
E3 • Contact an Authorised Service Centre.
E4 • Close the water tap and contact an Au‐
thorised Service Centre.
Ed • Contact an Authorised Service Centre.
The necessary information for the
Service Centre is on the rating plate.
record this information:
• Model ......................
• Serial number (SN.) ......................
ENGLISH 15