Electrolux EUC40G1 Instruction Manual page 40

chopsticks, etc.
I7 Alarm
Message signal will be sent in case of general
dishwasher fault.
For example
Both " Er- " and " 001 " are ON:
Faulty rinsing temperature sensor 1 (R1)
Troubleshooting:
1. Check that the resistance of the rinsing
temperature sensor is normal.
2. Check that the resistance of the rinsing
temperature sensor is connected.
(If the above conditions are normal, please call
the Service Center)
Alarms of troubles, causes/remedies
Alarm fault:
Er-001
Faulty rinsing temperature sensor 1
(R1)
Er-002
Faulty rinsing temperature sensor 2
(R2)
Er-002
Faulty main washing temperature
sensor (R3)
Er-011
Faulty heating of rinsing
Er-040
Faulty initialized communication
Er-041
Faulty ON-state communication
I8 End of Services and Routine Internal
Cleaning
Switch off the equipment power supply before
any cleaning operation.
Important Information!
Wash the stainless steel surface with warm
soapy water. Never use progressive detergent
or steel scraper, common steel wire wool,
brush or scraping straightedge. Wipe to dry
using warm cloth after wetting.
Use soft wet cloth and neutral detergent (if
necessary) to clean the control panel. Never
directly spray pressurized water onto the
washing equipment.
To reduce pollution to the environment, please
use product of which 90% components may be
biodegradable to clean the equipment (external
parts and internal parts to be cleaned).
Open the cover when the equipment is not in use.
I9 Correct Use
Everyday finish work with dishwasher, please
drain thoroughly the water tank
If the dishwasher is not in use for a long time (for
example, for a month), please observe the
following instructions.
•
Close the water tap;
•
Drain thoroughly the water tank;
•
Take out and carefully clean the filter.
•
Drain thoroughly the distributor hoses and
take them out of the vessel.
•
Drain thoroughly the boiler.
• See I8 " End of Services and Routine Internal
Cleaning " for washing operation of the
external and internal parts of the machine.
•
Apply a layer of wax film onto the stainless
steel surface.
For re-putting into service of the machine, please
follow I4 " Daily Activation of Machine " .
I10 Machine Disposal
After the equipment service life is expired, ensure
that the equipment will not be abandoned. The
equipment must be disposed of according to the
33