Fisher & Paykel RS2474S3RH Installation Manual page 28

SECURE DOOR PANEL
5
6
28
Open the door and loosen the lower
bracket screw. Adjust the bracket until it
rests against the door panel. Re-tighten
the screw and fit an additional screw to
secure to panel.
Install kit E
Recheck all gaps and any clashing.
FIT TRIMS AND GRILLE
1
2
3
4
Fit the top cover using two screws.
Ensure flat side faces out from
the panel.
Locate the shorter door trim to the
hinge-side of the product, and slide
down to clip in place. If a gap is present,
remove and readjust the side brackets.
Locate the longer door trim to the non-
hinge-side of the product and slide
down to clip in place. If a gap is present,
remove and readjust the side brackets.
Ensure trim does not protrude above
the top cover.
Hinge swap installs only:
Swap the bottom hinge and non-hinge
trims on the grille.