Table of Contents
Advertisement
Using the Camera Remote Unit RM-1
With the camera in the remote mode, you can release the shutter without touching the
camera using the RM-1 remote control. The shutter will release 2 seconds after
pressing the transmit button on the remote unit.
5
Eyepiece
shutter lever
Remote control
mark
Working range of the remote unit
Use the remote in front of the camera within the range of distances and angles shown below. The
following elements could narrow the working range of the remote/self-timer sensor: direct sunlight or
any other strong light source, fluorescent light, or any device emitting electrical or radio waves.
Remote unit
122
OFF
ON
1
3
Approx. 5m
(16.6ft.)
(indoor)
15°
15°
Approx. 3m
(outdoor)
(10ft.)
1
Set the mode dial to P, A, S, or M.
2
When the monitor is displayed, if
you press the monitor button
the display goes off. The remote
control cannot be used with the
monitor display on.
3
Press and hold down the drive
button
, and then turn the main
dial or the sub dial until you see
the remote control mark appear in
the control panel.
4
Mount the camera on a tripod and
compose the picture.
If the subject is not yet composed in the
center of the viewfinder, you can use focus
lock. (© 65) If you are going to include
yourself in the picture, focus on the area
where you intend to appear in the picture.
Camera
,
Advertisement
Table of Contents
