Table of Contents
Advertisement
de
Set up and connect the device
Align the device
Hints
All device feet must be firmly on the
■
floor.
If the devices are incorrectly aligned,
■
noises, vibrations and an uneven drum
can occur and residual water may leak
out of the device.
Align the device as follows:
1.
Loosen the lock nuts with a 17 mm
wrench in a clockwise direction.
2.
Align the device by turning the device
feet. Check alignment with a spirit
level.
18th
3.
Tighten the lock nuts hand-tight against
the housing with an SW17 wrench. Hold
the foot firmly and do not adjust the
height.
Before first use
Before you start using the device:
Check the device for visible damage. Do
not operate a damaged device. If you have
any complaints, inform your specialist
dealer or our customer service.
Your device was checked in detail before it
left the factory. Wash the first time
without Wash to remove possible test
water residues.
Run the program without laundry
as follows:
1.
Turn the program selector to switch
on the appliance.
Advertisement
Table of Contents
