Table of Contents
Advertisement
3.
Loosen and remove the screws on the
horizontal transport strut.
4th
Remove the transport strut.
Connect device
Caution!
Property and equipment damage
Too low or too high a water pressure
■
can impair the function of the device
and lead to property and device
damage.
Make sure that the water pressure on
the water supply system is at least 100
kPa (1 bar) and a maximum of 1000 kPa
(10 bar).
■
Modifying or damaging the water
S.
ax and device damage
hoses can lead to property damage
and damage to the device.
The water hoses must not be kinked,
squeezed, modified or cut.
■
The use of non-original hoses to
S.
ax and device damage
connect to the water supply can lead
to property damage and damage to
the device.
Use only the hoses supplied or
original replacement hoses.
Set up and connect the device
Hints
In addition to the information listed
■
here, special regulations of the
responsible water and electricity
company may apply. If in doubt, have
the device connected by qualified
■
personnel.
Hose and cable lengths
Right-hand connection
■
Left-hand connection
■
A.
90 cm
B.
195 cm
C.
135 cm
D.
60cm ~ 100cm
E.
135 cm
F.
150 cm
G
90 cm
If the inlet hose is too short for your
connection, you can order an extension
from customer service. ~ Page 19
de
15th
Advertisement
Table of Contents
