Table of Contents
Advertisement
Quick Links
Flow Fan- Installation instructions
Should you have any questions or difficulty installing your new fan,
please contact Modern Fan Co. customer service immediately.
Note: Power supply must be turned off prior to any contact with electrical wires. It is
recommended that a licensed electrician be hired to install your ceiling fan.
(1) Remove and identify contents of carton.
bottom cap
fan body
balancing
(2) If installing an optional light kit, begin by identifying all parts. Then follow steps
(a) through (e). Otherwise, skip to step (3).
bridge connector
light kit
hardware
diffuser and
trim ring
hanging bracket
hardware
down
kit
package
rods
Flow
THE MODERN FAN COMPANY
Customer Service
M-F 8am - 4pm (PST)
(ph) 888.588.3267
www.modernfan.com
blade top plates
canopy
optional
control
half
blades
ball
LED board
LED lighting
plate
LED cover
adapter plate
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for The Modern Fan Company Flow
Summary of Contents for The Modern Fan Company Flow
- Page 1 M-F 8am - 4pm (PST) (ph) 888.588.3267 www.modernfan.com Flow Fan- Installation instructions Should you have any questions or difficulty installing your new fan, please contact Modern Fan Co. customer service immediately. Note: Power supply must be turned off prior to any contact with electrical wires. It is recommended that a licensed electrician be hired to install your ceiling fan.
- Page 2 LED Light Kit Installation- Depending on when your fan was produced, several of these steps (a) through (c) may already have been completed for you prior to shipment. (a) Remove standard lighting plate. Set screws aside for attachement of LED lighting plate. Then join bridge connector with light kit lead wires coming out of fan.
- Page 3 (6) Slide fan canopy over down rod and carefully rest on top of fan body. canopy (7) Reinstall half ball from step (4) on end of down rod. Be sure that stopper pin is inserted through down rod and seated in half ball. Tighten set screw against down rod. stopper pin set screw (8) Using blade top plates and blade screws from hardware...
- Page 4 (14) Install optional wall control as described in the control installation instructions (unless using handheld remote control only). (15) Your fan is reversible for summer and winter operation. The reverse switch is located on the top of the fan body. When reading the REVERSE label, the LEFT position is for summer and the RIGHT position is for winter.
Need help?
Do you have a question about the Flow and is the answer not in the manual?
Questions and answers