Brennenstuhl LuxPremium LED, TL 800 AF Manual

Brennenstuhl LuxPremium LED, TL 800 AF Manual

Also See for LuxPremium LED:

Advertisement

Brennenstuhl LuxPremium LED, TL 800 AF Manual

SAFETY INSTRUCTIONS

  • Read the operating instructions carefully prior to use.
  • Do not use the torch if it is damaged.
    Please contact an electrician or write to the service address provided.
  • Do not look directly into the light.
  • Do not use the flashlight in an explosive environment as this poses a fatal risk!
  • Only use a certified USB source to charge the batteries.

OPERATION

  • Drain the battery completely and recharge before using the lamp for the first time.
  • 2 possible modes of operation
    • Push the switch (1): 100% - off - 40% - off - 10% - off - strobe - off - SOS - off
    • Soft-touch function by tipping the switch: 100% (push) - 40% - 10% - strobe - SOS - off (push).
  • The flashlight CANNOT be used while charging.
  • Charging indicator: red (5) during charging, green (6) when the battery is charged.
  • If the lamp is not used for an extended period of time, it is recommended that the battery be charged every 3 months.

OVERVIEW OF THE CONTROLS

Controls

  1. On/Off switch
  2. Switch end piece
  3. Charger socket
  4. Focus
  5. Charging indicator (Red)
  6. Charging indicator (Green)
  7. USB charging cable
  8. LED head part

CHARGING

Screwing off the switch end piece (2)

Only charge your battery using a USB charging cable (7). Exclusively use a certified USB power source (e.g. charging device, computer) with a maximum of 5 V output voltage:

Connection: USB source – USB charging cable (7) – charging socket (3)

Screwing the switch end piece (2) down.

During the charging process, the product is not IP67-compliant (dust-tight and protected against temporary immersion in water).

BATTERY EXCHANGE

Screw off the LED head part (8), remove and replace the battery, screw the LED head part (8) down firmly.

Replacement batteries can be purchased from Hugo Brennenstuhl (see address) under the art. no. 0293144.

TECHNICAL SPECIFICATIONS

LED: CREE-LED

USB charging input: 5 V/2 A (micro USB)

Flux: 860 lm

Charging time: ~ 4 hrs

Battery: YK ICR 18650 dual pole 3.7 V/4.0 Ah

Protection class: IP 67

Temperature range: -10°C - +40°C

DECLARATION OF CONFORMITY

The declaration of conformity is stored at the manufacturer's.


Do not dispose of electrical appliances, batteries and rechargeable batteries with your household rubbish.
Waste electrical and electronic devices, batteries and rechargeable batteries are classified as hazardous waste. They must be collected separately from general waste to be recycled in an environmentally compatible manner.

For more information, we recommend the Service/FAQs area on our homepage www.brennenstuhl.com.

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Brennenstuhl LuxPremium LED, TL 800 AF Manual

Advertisement

Need Assistance?

Do you have a question about the LuxPremium LED that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents