Tacx FLUX 2 Smart - Trainer Manual

1. Check if everything is in the package
   
   
2. Lay the trainer down on its side
   
   
3. Place the cassette on the body by aligning the markers
   Campagnolo cassette: other body required, available at Tacx webshop
   Please consult the Tacx website for an updated list with fitting cassettes
4. Mount the cassette according to the instructions provided in the manual of the cassette
5. Slide the front leg in the trainer and fix it with the 2 bolts
   
   
6. Place the trainer on a firm, level surface
   
   
7. Select the needed quick release. Place the T2835 for 142x12 or 148x12 mm axles according to the instructions supplied with the axles. Use the fill ring in case of axle length 135 mm
   
   
8. Place the bike in the trainer
   

Safety instructons

• Tests have revealed that the unit will not overheat, even when subject to extreme use. However, when subject to prolonged and intensive use, the enclosure around the brake may become very hot. Always allow the brake to cool down after use before touching it.
• Ensure not to drop the brake during assembly as this can lead to an imbalance which may cause vibration.
• Never open the brake unit as this may cause damage.
• Inspect the nuts and bolts on the trainer on a regular basis, and retighten if necessary.
• Perspiration moisture and condensation can harm the electronics. Do not use the trainer in damp areas. Incorrect use and/or maintenance will void the warranty.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack or experience and knowledge if they have been given supervision or instruction concerning use of appliance in a safe way and understand the hazards involved.
• Children are not to play with the Tacx trainer without supervision.
• This device is not designed for industrial, commercial or medical applications.
• Do not expose the product to water or moisture.
• Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
• In case of not using the trainer, switch it off and unplug the mains.
• Keep the trainer in a dry room at room temperature.
• Always allow the brake to cool down for 20 minutes after use before touching it.