Tacx NEO 2 Smart Quick Start Guide

Table of Contents

Assembly

Check if everything is in the package
Lay the trainer down on its side
Determine the needed connector based on the cassette

Campagnolo cassette: other body required, available at Tacx webshop.
Please consult the Tacx website for an updated list with fitting cassettes
Mount the cassette according to the instructions provided in the manual of the cassette
Unfold the trainer and place it on a firm, level surface
Select the needed quick release. Place the T2835 for 142x12 or 148x12 mm axles according to the instructions supplied with the axles. Use the fill ring in case of axle length 135 mm
Choose to train with or without mains power
Fold the trainer to store it

Problem A: the derailleur hits the NEO 2 when using the lightest gear

Remove the Body including the cassette with an allen key 5mm. Make sure the black ring remains attached to the Body.
Slide the 2 supplied spacers (T2805.11 and T2805.12) to the back of the axle.
Place the Body, with the black ring, and the cassette back in position.

Tests have revealed that the unit will not overheat, even when subject to extreme use. However, when subject to prolonged and intensive use, the enclosure around the brake may become very hot. Always allow the brake to cool down after use before touching it.
Ensure not to drop the brake during assembly as this can lead to an imbalance which may cause vibration.
Never open the brake unit as this may cause damage.
Inspect the nuts and bolts on the trainer on a regular basis, and retighten if necessary.
Perspiration moisture and condensation can harm the electronics. Do not use the trainer in damp areas. Incorrect use and/or maintenance will void the warranty.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack or experience and knowledge if they have been given supervision or instruction concerning use of appliance in a safe way and understand the hazards involved.
Children are not to play with the Tacx trainer without supervision.
This device is not designed for industrial, commercial or medical applications.
Do not expose the product to water or moisture.
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
In case of not using the trainer, switch it off and unplug the mains.
Keep the trainer in a dry room at room temperature.
Always allow the brake to cool down for 20 minutes after use before touching it.