Advertisement
Energy Saver Button
Quick Chill Button
We offer an optional air filter that magnetically attaches to the rear
of the cooling unit.
To replace the filter, remove the filter frame from the cooling unit
(see the image at right), and replace the fiberglass membrane
when it becomes dirty (anywhere from 3 to 9 months depending
on the conditions in your location.) The air filters are disposable,
they cannot be cleaned.
When replacing the filter, the blue fibers should face the cooling unit, and the white fibers
should face away from the cooling unit.
Replacement filters may be purchased at www.cellarpro.com.
To activate and deactivate the "Energy Saver" mode, press
the "Energy Saver" button
The "Energy Saver" indicator light will turn on when the
cooling unit is in "Energy Saver" mode
In "Energy Saver" mode, the Minimum Set Point increases
4°F and the Temperature Differential is unchanged
To activate the "Quick Chill" mode, press the "Up" / "Quick
Chill" button for three seconds
To deactivate "Quick Chill", press "Quick Chill" button for
three seconds again
The "Quick Chill" indicator light will turn on when the
cooling unit is in "Quick Chill" mode
In the "Quick Chill" mode, the cooling unit will run
continuously for 6 hours (or until the intake temperature
registers 50°F). This mode is useful after loading "warm"
bottles in a cellar
AIR FILTER
21
v3.21
Advertisement
