Harken E2700 Instructions

USA – Tel: (+1) 262-691-3320 • Web: www.harken.com • Email: harken@harken.com
Italy – Tel: (+39) 031.3523511 • Web: www.harken.it • Email: techservice@harken.it
27 mm Midrange Endstops and End Controls (Sold as a Pair)
Strictly follow all instructions to avoid an accident, damage to your vessel, personal injury
or death. See www.harken.com/manuals for additional safety information.
IMPORTANT: See Inspection and Maintenance at end of manual.
Fasteners (One Set for Each Control):
1 (one) / " (8 mm) flathead A4 (316) or A2 (18-8)
5
16
stainless steel mounting screw.
End control and track thickness is shown at right.
When purchasing fasteners, add deck thickness and
enough threads to extend below washer and nut.
1 (one) washer
1 (one) locknut for each end control.
/ " (8.5 mm)
Drill Bit:
11
32
Max line
Ø
Part
No. in mm
/ 10
E2730
3
8
E2750 / 10
3
8
Note: E27 end controls do not fit older non-CB track.
The E27 end controls' interior ridges that extend into the
waist of the track are too deep to fit non-CB track. E27 end
controls require deep grooves for wire keepers on CB cars.
R27 low-beam track has holes drilled for end controls
and enstops if entire length is used. If you shorten one
end, make cut so end control screw passes through a
track fastening hole. It is best to have track cut with an
electric cross cut saw at a machine shop. Low beam
track may be cut using a hacksaw but it is difficult to get
a straight, even cut. Measure from center of hole to end
of track so center is /
9
does not work, make sure that end control screw hole
does not interfere with mounting or pinstop hole.
Note: Since trim caps are not used with E27 or
E32 end controls, do not leave room for them.
I N S T R U C T I O N S
E2700, E2730, E2750, E2756
Fits R27 and Midrange CB Track
See www.harken.com/manuals for more instructions
Fasteners — Not Included
Maximum Breaking
working load load
lb kg lb kg
1800 816 3600 1633 1:1, 2:1
1800 816 3600 1633 3:1, 4:1
" (14 mm) from track end. If this
16
Specifications
Max line
Part
Purchase No. in
/
E2756
3
8
Mounting to Track
E27 end controls
require deep grooves
for wire keepers on
CB cars
Drill Size / " (8.5 mm)
11
32
2 /
1
8
55 mm
Subtract 1/8" (2.5mm) from
numbers above to determine
Maximum
Ø working load
mm lb kg
10 600 272
/ " (15 mm)
19
32
/ " (14 mm)
9
16
Track Mounting Hole
End Control
Hole
R32
1 /
1
8
28 mm
E2700 Endstop
screw length.
Breaking
load
lb kg Purchase
1500 680 3:1, 4:1