EPOX EP-8RDAE User Manual page 12

Introduction
I/O Shield Connector
PS/2
Mouse
PS/2
Keyboard
Power-On/Off (Remote)
Note: For maintaining the DDR SDRAM power during STR (ACPI S3) function, it is
strongly recommended to use ATX power supplies that have a +5VSB current
of (>=) 1A (1000mA). Please check the 5VSB’s specification that has been
printed on the ATX power supply’s outer case.
Note: The board requires a minimum of 250 Watt ATX power supply to operate. Your
system configuration (amount of memory, add-in cards, peripherals, etc.) may
exceed the minimum power requirement but to ensure that adequate power is
provided, use a 300 Watt (or greater) ATX power supply.
PW-ON
Case (chassis) Power ON/OFF button (PW-ON)
Figure 4: Simple ATX power ON/OFF controller
Page 1-6
Parallel Port
USB2.0 ports
Figure 3: I/O back panel layout
Remote On/Off
RJ45 LAN
(Optional)
Line-in/Rear out (Blue)
Line-out/Front out (Green)
Mic-in/Center&Subwoofer (Pink)
®
12V 4-pin
20-pin
POWER SUPPLY