Table of Contents
Advertisement
62
4.6.3
Setting gas adjustment :
The machine is adjusted at the plant to be suitable for the kind of gas specified on the order. If you have to supply
your machine with gas in a familly different from the gas for which your machine was adjusted , proceed as follows :
Check that the diameter of the injectors is adequate for the kind of gas of your installation (see Table of injectors be-
low). The machine is delivered with extra injectors in a plastic envelope.
4.6.3.1
Changing to a gas in the same family (Type H or L):
Adjust the gas outlet pressure (see correspondence in the tables below)
4.6.3.2
Changing to a gas in a different family (from type H or L to butane or propane)
Change the 3 injectors with joints (see correspondence in the tables)
Unscrew the fixing screws (V) and remove the adjusting head (J) as weel as its cork (T), keep these parts in case a
change would be necessary.
Replace it by the cork (L) and the plate (P).
Screw the 2 screws and block.
4.6.3.3
Changing to a gas in a different family (from butane or propane to type H or L)
Change the 3 injectors with joints (see correspondence in the tables)
Unscrew the fixing screws (V) and remove the plate (P) as weel as its cork (L), keep these parts in case a change
would be necessary.
Replace it by the cork (T) and the adjustment head (J).
Screw the 2 screws (V) and block.
Installation manual
Advertisement
Table of Contents
