Troubleshooting - Husqvarna S 138i Operator's Manual

WARNING:
when you do maintenance on the dethatcher
equipment. The blades on the dethatcher
equipment are very sharp and cuts can
easily occur.
• Examine the dethatcher equipment for damage
or cracks. Always replace a damaged dethatcher
equipment.
To replace the dethatcher equipment
WARNING:
when you do maintenance on the dethatcher
Battery
LED on the battery
The green LED flashes.
The error LED flashes.
The error LED is on.
Battery charger
LED on the battery
charger
The error LED flash-
es.
The error LED is on.
Control panel
For model S 138i
937 - 006 - 05.10.2022
Use protective gloves
Use protective gloves

Troubleshooting

Cause
The battery voltage is low.
The battery is weak.
The temperature in the work environ-
ment is too high or too low.
Overvoltage.
The cell difference too much (1V).
Cause
The temperature in the work en-
vironment is too high or too low.
equipment. The dethatcher equipment is
very sharp and cuts can easily occur
1. Put the product on its right side. (Fig. 54)
2. Remove the 2 screws (A) and the dethatcher cover
(B). Push the dethatcher equipment (C) up and out
to remove it. (Fig. 55)
3. Push the new dethatcher equipment (C) into the
groove and down the hole. Attach the dethatcher
cover (B) and the 2 screws (A) (Fig. 56)
Solution
Charge the battery. Refer to
on page 20 .
Charge the battery. Refer to
on page 20 .
Use the battery in temperatures between -10°C
and 40°C.
Make sure that the mains voltage is the same as
on the rating plate on the product.
Remove the battery from the battery charger. Wait
5 seconds and try again to charge the battery.
If the problem continues, speak to an approved
service agent.
Speak to an approved service agent.
Solution
Use the battery charger in temperatures between 5°C
and 40°C.
Speak to an approved service agent.
To charge the battery
To charge the battery
23