Exit Alarm Panel - Nortel DMS-100 Series Reference Manual

4-8 Version 2 Enhanced Alarm System
the alarm display panel are the same as those on the ACD. Table 4-1
describes these functions.
Figure 4-4
Alarm display panel
Power
Critical
Dist
R
System
Center
ABS
Major
Office
A
System
Alarm
Unit
Minor
Critical
W
System
Power
Plant
Major
Major
Other
Y
Power
System
Plant
Minor
Minor
G
Other
Power
System
Plant
Legend: Lamp A = amber
Lamp G = green
Lamp R = red
Lamp W = white
Lamp Y = yellow

Exit alarm panel

The exit alarm panel (NT0X64) is near the main exit door on each floor in a
multi-floored DMS office. Figure 4-5 shows this panel. Normally, you can
install a maximum of four exit alarm panels in a DMS office. For more
information, refer to the Alarm extension circuits section in this chapter.
The exit alarm panels direct maintenance personnel to the area or floor of
the office where detection of the alarm condition occurred. The exit alarm
panels provide remote controls for the night alarm transfer and alarm
grouping circuits. The functions of the lamps and switches on the exit alarm
panels are as follows:
297–1001–122 Standard 06.01 August 1999
R
Power
Dist
A
Center
R
Audible
A Alarm
Reset
W
The night alarm transfer switch and lamp have the same functions as
these devices on the ACD. These functions are described in Table 4-1.
The alarm grouping switch and lamp have the same functions as these
devices on the ACD. These functions are described in Table 4-1.
The yellow power plant lamp lights to signal an alarm condition in the
DMS power plant.
Night Alarm
Transfer
W
A
Alarm Alarm
Grouping Transfer
W
W
Office
Alarm
System