Alexa; Fitting And Removal Of The Hose; Navegation Menu Interface - V2C Trydan User Manual

7. ALEXA

Pair your Alexa device with your e-Charger for a voice-controlled, immersive technology
experience.
Pair your e-Charger with Alexa by following the instructions below:
https://v2charge.com/wp-content/uploads/2022/05/Link-Alexa.pdf
Get to know Alexa's functional commands:
https://v2charge.com/alexa-functional-commands/

8. FITTING AND REMOVAL OF THE HOSE

Positioning the hose
1. Insert the hose into the holder, leaving a small gap at the bottom so
that it does not collide with the integrated locking clip.
2. Slide the hose down to snap it into the integrated locking clip
Removing the hose
1. Slide the hose upwards to release it from the locking clip.
2. Pull the hose outwards, removing it out of the hose holder.

9. NAVEGATION MENU INTERFACE

Trydan has two buttons at the top of the left side.
With these two buttons we can change the parameters (by long presses) and change the
property we wish to modify (by long presses). The upper button is assigned to forward (+) and
the lower one to backward (-).
To enter the configuration menu, both buttons must be held down for 2 seconds. The charger
must not be locked.
Language
The first parameter that we can change is the language. With long presses,
we can select between Portuguese, English or Spanish. Once the desired language has been
selected, we will advance to the next parameter with a short press on the upper button.
Locking clip
8