Hunter 51059 Installation Manual page 7

1
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
4
Partially install two of the switch housing screws
found in the bag. Connect the plugs from the
upper and lower switch housings. Make sure
to line up the colored markings on the plug
connectors.
Ceiling Bracket Hanging Fan
Assembling Switch Housing
2
2 of 6
Light Kit Screw
bag
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
2 of 6
Machine Screw
bag
Installing the Pull Chains
Wiring
5
bag
Align the notches in the sides of the lower
switch housing with the screws on the
upper switch housing. Twist the lower
switch housing clockwise to lock into place.
Install the third switch housing screw.
Tighten all three screws securely.
Connect the fan pull chain pendant to
the short chain coming from the switch
housing.
The fan pull chain controls
the speed: from high to off.
Motor Housing
3
bag
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
1 of 6
Machine Screw
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Blades Switch Housing
1886
1 of 6
Light Kit Screw
6