Table of Contents
Advertisement
Wakeup Event Setup
Press <Enter> and the following sub-menu appears:
Resume by PCI-E Device
This controls how and whether the system can be powered on by the devices
installed on PCI-E slots. Setting options: [Disabled], [Enabled].
Resume by PCI Device (PME#)
When setting to [Enabled], this setting allows your system to be awakened from the
power saving modes through any event on PME (Power Management Event).
Setting options: [Disabled], [Enabled].
Resume by RTC Alarm
This is used to enable or disable the feature of booting up the system on a
scheduled time/date from the S3, S4, and S5 power off state. Setting options:
[Disabled], [Enabled].
Date (of M onth) Alarm
The field specifies the date for Resume by RTC Alarm. Settings: 0~31.
Time (hh:mm:ss) Alarm
The field specifies the time for Resume by RTC Alarm. Format is <hour>
<minute><second>.
Restore on AC Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
[Off]
[On]
[Last State]
Leaves the computer in the power off state.
Leaves the computer in the power on state.
Restores the system to the previous status before power
failure or interrupt occurred.
4-13
Chapter 4 - BIOS Setup
Advertisement
Table of Contents
