Table of Contents
Advertisement
Access M ode
Capacity
Cylinder
Head
Pr eco mp
Landing Z one
Sector
MSI Reminds You...
IDE Third/ Fourth/ Fifth/ Sixth Master are appearing when you
connect the HD devices to the SATA connector on the mainboard.
Drive A
This item allows you to set the type of floppy drive installed. Available options: [None],
[360K, 5.25 in.], [1.2M, 5.25 in.], [720K, 3.5 in.], [1.44M, 3.5 in.], [2.88M, 3.5 in.].
Halt On
The setting determines whether the system will stop if an error is detected at boot.
Available options are:
[All Errors]
[No Errors]
[All, But Keyboard]
[All, But Diskette]
[All, But Disk/Key]
Base/Extended/Total Memory
The three items show the memory status of your system (read only).
The settings are CHS, LBA, Large, Auto.
The formatted size of the storage device.
Number of cylinders.
Number of heads.
W rite precompensation.
Cylinder location of the landing zone.
Number of sectors.
The system stops when any error is detected.
The system doesn't stop for any detected error.
The system doesn't stop for a keyboard error.
The system doesn't stop for a disk error.
The system doesn't stop for either a disk or a key-
board error.
4-7
Bios Setup
Advertisement
Table of Contents
