Table of Contents
Advertisement
Maintenance
Main unit/dryer filter/detergent case
● When "Filter Clean" flashes, please confirm the
following filter cleaning.
● After "Dry Mode" is over
● After "Wash" with StainMaster+
Dryer filter
The display of "Filter clean" is to inform that a certain amount
of lint has adhered to the dryer filter.It is possible that flashing
occurs even after one operation, but it is not a malfunction.
Remove the lint.
1
Remove the dryer filter.
2
Wipe clean with a wrung out towel.
●
Do not rub hard ( to avoid filter damage)
No filter
Remove the lint from the dryer filter
3
(inside).
Remove the dryer filter (inside) and
4
wash with water.
5
Install the dryer filter.
●
Put in the whole filter completely.
●
Do not operate the dryer with the
filter screen removed (so as to avoid
inaccurate drying or raising dust).
40
NA-V180HDH(s)_160HDH(s)-English.indb 40
●
D o not remove while in
operation.
●
After removing the filter,
do not wash the side of
the machine body or put
anything into it.
●
When the mesh is blocked,
wash thoroughly with warm
water and then fully dry.
●
Remove lint, and then wipe it
with a wrung out towel.
Dryer filter (inside)
Detergent case
Water wash
Hold down the circular recess
1
and pull it out.
2
Remove the lid and clean the
inside of the detergent
case and the inside of
the lid (P. 51).
Attention
• Leaving the dirt untreated will cause mold.
Moreover, the adhesion of dirt will make the
softener not easy to flow.
Removal
1
Remove it to take
out the lint.
Water wash
2
Rinse with
running water,
then rub with
your fingertips
while washing
(do not use a
brush).
Install
3
② Hold down
Install after it's
completely dry.
① Insert
2022/6/10 下午 10:27:28
Advertisement
Table of Contents
