Table of Contents
Advertisement
Touch Panel
❶
Power switch
On
Off
Press when the power is turned on.
●
The machine will automatically shut down after washing.
●
If the [Start/Pause] button is not pressed after the power is
turned on, the machine will automatically turn off after 10
minutes.
●
The power button must be pressed for 2 seconds to switch on
or off the power.
❷
Start
Start/Pause
Pause
Press it to start or pause the operation, and when to open the
door during operation.
●
After starting, the switch among "Wash", "Wash+Dry" and "Dry
Mode" cannot be performed.
❸
nanoe
Y
ou can choose nanoe
"Refresh (static)" programs. (P.36)
●
After selecting the program, press it for 3 seconds to perform
"nanoe Tub Hygiene".
The program of nanoe
●
selected alone by pressing this button.
TM
nanoe
X and the nanoe
are trademarks of Panasonic Corporation.
❹
Wash
Select the program
Program
You can choose your preferred program according to the state of
the laundry and dirtiness.
●
How to choose the program → (P.18)
●
Under "Wash", "Wash+Dry", and "Drying", there are different
alternative programs.
❺
Stain
StainMaster+
Master+
deactivate child safety).
To set StainMaster+, or heat the water to about 30 °C for washing
when the water temperature is low. (P.13)
●
To prevent children from arbitrarily opening the door of the
washing machine and falling into the washing tub, press and
hold it for more than 5 seconds to set the "Child Lock". (P.15)
A
ECONAVI Operation
indicator
Light on: ECONAVI program is running.
Flashing: ECONAVI program is being detected.
B
nanoe Tub Hygiene
indicator
nanoe
X light on: The nanoe Tub Hygiene program is set.
TM
nanoe
X light flashing: The nanoe Tub Hygiene program is in
TM
progress.
C
Child Lock indicator
Light on: The Child Lock is set.
D
Wash+Dry indicator
Light on: The program selected is "Wash+Dry".
＊ After starting, the touch button will no longer be sensing. If you want to execute the action of the button, press "Start/Pause" before the execution.
＊ When water, detergent or softener drips onto the touch button, please turn off the power and wipe it clean to avoid malfunction.
＊ When touching the button, please touch the text part to select the operation (cannot be operated with nails, pens, rubber gloves, etc.).
＊ Do not operate the touch panel when your fingers are wet or when wearing gloves.
12
NA-V180HDH(s)_160HDH(s)-English.indb 12
E
G
F
❾
❽
❼
X
TM
TM
X "Pre care", "Refresh (rotate)", and
TM
X "nanoe Tub Hygiene" cannot be
TM
X mark
(press for 5 seconds to set/
D C
❻
❺
❹
❸
❻
Dry
Dry Mode
Mode
between Wash and Dry Mode)
You may choose the drying modes of "Normal Dry", "Extra
Dry", "Gentle Dry" and "Timed Dry" according to the state of the
clothes. (P.35)
●
Press for 3 seconds to select only "Dry Mode". (P.34)
❼
Scheduled ending time
Preset
With 1 hour as the unit, set the number of hours (less than 24
hours) for the scheduled completion of Wash or Dry Mode.
●
The scheduled time varies depending on the program. (P.39)
●
For the "Wash+Dry" appointment, the time will be adjusted
automatically according to the type of clothes and the state of
dryness; the drying operation may be completed earlier or later
than the reserved time.
●
Do not use liquid soap when making an appointment. (P.22)
❽
Manual Setting
Wash
Rinse
Spin
You may choose the time or frequency of "Wash", "Rinse" and
"Spin".
●
When you want to change the selection, press
"Wash" to change. (it is not possible to change the program at
the beginning of the rinse program) (P.27)
●
Setting the combination of "Wash", "Rinse" and "Spin" accord-
ing to your purpose → (P.27)
❾
Water
Water Level
Level
release the door lock during drying)
Pause and then press it when you want to adjust the water level
other than the automatic water level of the laundry.
●
Depending on the program, some water levels cannot be
selected. (P.39)
●
At the end of the drying process when the temperature is
lowered, you can press for 3 seconds to cancel the drying and
unlock the door, and take out the clothes in advance.
E
Light on: Fluffy is set after the program is over.
:
Flashing: Fluffy is in progress after the program is
over.
: Flashing: Please clean and maintain the dryer
filter/exhaust filter/drain filter (P.40, 41)
F Display of "Remaining
Time"/"Scheduled Time"
Power "off" is switched to "on"
When
is displayed, you cannot "turn on" the power.
G
: Light is on: The program is in progress, and the
door lock is on.
●
After starting, the door will be automatically
locked.
A
B
❷
❶
(press for 3 seconds to switch
Start
during the
Pause
(press for 3 seconds to
2022/6/10 下午 10:27:01
Advertisement
Table of Contents
