Hover-1 RAPTOR Operation Manual page 7

2. Insert the left and right handlebar mounts into the seat frame as shown below. Align the holes of the handlebar
mounts with the holes in the seat frame. Align the hole of the ag holder with the hole in the seat frame on either
side. This will be where the ag is inserted later. Insert the 8 X 38 screws into the seat frame holes and attach the 8
mm nuts to the end of the screws by twisting them on clockwise. Hold the screws in place with the hex key and
turn the nuts clockwise with the wrench to tighten them. Make sure the screws and nuts are tightly secured.
Tools
needed
x 2
3. Insert the front frame into the seat frame. Adjust the front frame to your preferred length. Remove the black bolt
and the rst white washer from the end of each locker. Fully insert the screwed section of one locker into the seat
frame holes. Add the white washer and black bolt back onto the locker once it is fully inserted and twist them on
clockwise until they are tightly secured. Close the locker clamp tightly. Repeat these steps on the other side of the
seat frame with the other locker.
6