Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec BM40
Summary of Contents for Trotec BM40
- Page 1 BM40 ORIGINAL INSTRUCTIONS MOISTURE MEASURING DEVICE...
-
Page 2: Table Of Contents
• Remove the batteries from the device if you will not be using the device for a longer period of time. • Never short-circuit the supply terminal in the battery compartment! moisture measuring device BM40... - Page 3 To use the device for its intended use, only use accessories and Warning spare parts which have been approved by Trotec. The device is not a toy and does not belong in the Foreseeable misuse hands of children.
-
Page 4: Information About The Device
Device depiction Information about the device Device description The device BM40 is suited for the non-destructive material moisture measurement in mineral building materials and wood. The measuring probe is pressed against the material to be tested. The moisture level is then measured by capacitive... -
Page 5: Transport And Storage
After approx. 10 min Dimensions (length x width x height) 168 x 35 x 75 mm Weight 220 g Scope of delivery • 1 x Moisture measuring device • 1 x 9 V battery • 1 x Quick guide moisture measuring device BM40... -
Page 6: Operation
ð The measured value is displayed in real time on the The device switches off after approx. 10 minutes of non-use. measurement value display (8). 1. Press the Power button (3) for approx. 3 seconds. ð The device switches off. moisture measuring device BM40... -
Page 7: Measuring Principle
• Another important variable influencing the measured value is the bulk density of the good to be measured. The higher the bulk density, the higher the measured value. moisture measuring device BM40... -
Page 8: Maintenance And Repair
– Ideally, the moisture should be evenly distributed within the material to be measured. Quantitative conclusions about the moisture content of the mineral material to be measured can only be drawn by applying the Darr procedure or the CM method. moisture measuring device BM40... -
Page 9: Disposal
According to Waste Electrical and Electronic Equipment Regulations 2013 (SI 2013/3113) (as amended) and the Waste Batteries and Accumulators Regulations 2009 (SI 2009/890) (as amended), devices that are no longer usable must be collected separately and disposed of in an environmentally friendly manner. moisture measuring device BM40... - Page 10 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...