Securing Child; Installation Without Base - Joie i-Jemini Safety Manual

Enhanced child restraint
Hide thumbs Also See for i-Jemini:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Securing Child

in the enhanced Infant Child Restraint
see images
-
18
23
Note
1. Infant insert is for children's protection. Children whose height
is under 60cm are suitable to use the infant insert.
2. Before using the insert, please add the foam wedge.
3. After the child is placed in the seat, check if the shoulder
harnesses are set to the correct height.
Remove the body portion of the infant insert
when the infant's shoulders no longer fit
comfortably.
1. While pressing the harness adjustment button, pull completely the
two shoulder harnesses of the enhanced infant child restraint.
2. Unlock the buckle of the harnesses by pressing the red button.
3. Place child into the infant carrier module and lock the buckle.
4. Tighten the shoulder harnesses by pulling adjustment webbing.
Detaching Canopy and Seat Pad
see images
-
24
29
To re-assemble the soft goods, reverse the aforementioned steps.
15

Installation without base

see images
!
DO NOT install this infant carrier module on vehicle seats with Lap
Belts.
!
This infant carrier module is suitable for vehicle seats with a 3-point
Retractor Safety Belt only.
1. Place the infant carrier module onto the vehicle seat where you wish
18
to put it. Pull the vehicle safety belt out and lock it into the vehicle
buckle, sliding the vehicle lap belt into the side guides of the infant
carrier module.
!
The infant carrier module can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the infant carrier
module securely.
2. Slide diagonal belt into the rear guide.
3. Pull the vehicle shoulder belt to fasten the infant carrier module
tightly and securely.
4. Level line on infant carrier module must be level to the ground when
19
the infant carrier module is installed.
20
!
Tension the vehicle safety belt as much as possible, checking that it
&
21
22
is not loose or twisted.
23
!
After installing the infant carrier module, always check that the
vehicle belts are routed correctly and securely fastened into the
vehicle buckle.
5. The hood can be opened completely to protect your child from the
sun uttermostly, just unzip the hook, and then pull the hood toward
front.
-
30
37
30
31
32
-2
32
34
36
37
33
35
16

Advertisement

Table of Contents
loading

Table of Contents