Height Adjustment - Joie i-Jemini Safety Manual

!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg adjustment button, then shorten the load leg
upwards. -1
5
6. The completely assembled base is shown as
!
The ISOFIX connectors must be attached and locked onto the
6
ISOFIX anchor points. -1
!
The load leg must be installed correctly with green indicator.
!
Please install the enhanced child restraint on the rear vehicle seat
and then put the child in the enhanced child restraint.
7. Push the enhanced child restraint down onto the base
enhanced child restraint is secure, the enhanced child restraint
indicator will show green. 8
!
The enhanced child restraint can ONLY be installed and released
when in rearward facing mode.
8. Press the rotating button to rotate for easier side loading/unloading
of the child. 9
!
Rotate the enhanced child restraint to the rear facing position. The
enhanced child restraint indicator will show green.
9. To release the enhanced child restraint, first take the child out of the
child restraint. Pull the child restraint release button
the child restraint up -2.
11
10. To remove the base from the vehicle seat, push the secondary lock
buttons -1 first and then press the ISOFIX releasing buttons
12
on the ISOFIX connectors before removing the base from the vehicle
seat.
12
11.For transporting, press ISOFIX adjustment button and move the
ISOFIX connectors back into the storage position.
13
6
5 -2
. If the
7
10
-1, then lift
11
-2
12
13

Height Adjustment

for Head Support and Shoulder Harnesses
see images -
14 17
Check that Shoulder Harness Straps are set at the proper height.
Please choose the proper pair of shoulder harness slots according to
the child's height.
!
The bottom of headrest must be level with the highest point of
child's shoulder, it is shown as
15
!
If the Shoulder Harness Straps are not at proper height, the child
might be ejected from the enhanced infant child restraint if there is a
crash.
Squeeze the head support adjustment lever
push down the head support until it snaps into one of the 7 positions.
The head support positions are shown as
, but not above the shoulder line.
14
, meanwhile pull up or
16
17
14