Lowrance X-28 Installation And Operation Instructions Manual page 7

CAUTION! CAUTION! CAUTION! CAUTION! CAUTION!
CLAMP THE TRANSDUCER CABLE TO CLAMP THE TRANSDUCER CABLE TO
CLAMP THE TRANSDUCER CABLE TO CLAMP THE TRANSDUCER CABLE TO CLAMP THE TRANSDUCER CABLE TO
TRANSOM NEAR THE TRANSDUCER. THIS TRANSOM NEAR THE TRANSDUCER. THIS TRANSOM NEAR THE TRANSDUCER. THIS
TRANSOM NEAR THE TRANSDUCER. THIS TRANSOM NEAR THE TRANSDUCER. THIS
WILL HELP PREVENT THE TRANSDUCER WILL HELP PREVENT THE TRANSDUCER WILL HELP PREVENT THE TRANSDUCER WILL HELP PREVENT THE TRANSDUCER WILL HELP PREVENT THE TRANSDUCER
FROM ENTERING THE BOAT IF IT IS FROM ENTERING THE BOAT IF IT IS
FROM ENTERING THE BOAT IF IT IS FROM ENTERING THE BOAT IF IT IS FROM ENTERING THE BOAT IF IT IS
KNOCKED OFF AT HIGH SPEED. KNOCKED OFF AT HIGH SPEED. KNOCKED OFF AT HIGH SPEED. KNOCKED OFF AT HIGH SPEED. KNOCKED OFF AT HIGH SPEED.
POOR ANGLE POOR ANGLE
POOR ANGLE POOR ANGLE POOR ANGLE
4. Hold the transducer and bracket assembly against the transom. The
transducer should be roughly parallel to the ground. The bottom of the
transducer bracket should be in line with the bottom of the hull. Don't
let the bracket extend below the hull! Mark the center of the slots for
the mounting holes. Drill two 5/32" holes in the marked locations for
the #10 screws supplied with the transducer.
TRANSOM
SIDE VIEW
POOR LOCATION POOR LOCATION
POOR LOCATION POOR LOCATION POOR LOCATION
GOOD LOCATION GOOD LOCATION GOOD LOCATION GOOD LOCATION GOOD LOCATION
5
GOOD LOCATION GOOD LOCATION
GOOD LOCATION GOOD LOCATION GOOD LOCATION