Table of Contents
Advertisement
en Familiarising yourself with your appliance
Familiarising yourself with your
appliance
Familiarise yourself with the parts of your appliance.
Controls
Use the remote control to set all of the functions of
your appliance.
Tip: Align the remote control as precisely as possible
to the infrared receiver for the LED display.
Switch the appliance on or off
Switch on automatic mode
Increase the fan setting
Decrease the fan setting
Switch the lighting on or off
Reduce the brightness
Increase the brightness
Switch the fan run-on on or off
Switch Home Connect on or off
Reset the filter saturation indicator
1
Depending on the appliance specifications
LED display
Die LED-Anzeige zeigt eingestellte Werte und Funk-
tionen.
1 2 3 4 5
Fan setting 1/grease filter saturation display
1
Fan setting 2/odour filter saturation indicator
2
Fan setting 3
3
1
Depending on the appliance specifications
6
All manuals and user guides at all-guides.com
1
6
7
8
Intensive mode 1
4
Intensive mode 2
5
Automatic mode
6
ilation
Home Connect
7
Infrared receiver
8
1
Depending on the appliance specifications
Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
Setting an operating mode
Your appliance is set to air extraction mode by default.
To use it in circulating-air mode, you must set the oper-
ating mode.
Note: For use in circulating-air mode, you require addi-
tional Accessories.
Requirement: The appliance is switched off.
Press and hold and for approx. three seconds.
1.
To set circulating-air mode (non-regenerable fil-
‒
ter), press /
until LED 2 lights up in the LED
display.
To set circulating-air mode (non-regenerable fil-
‒
ter), press /
until LED 3 lights up in the LED
display.
To convert the electronic control back to opera-
‒
tion without the air recirculation filter, press /
until LED 1 lights up on the LED display.
To save the setting, press and hold and for ap-
2.
prox. three seconds.
Or wait approx. 10 seconds until the setting is
saved automatically.
To cancel the setting, press .
a A signal tone sounds as soon as the selected set-
ting is saved.
Basic operation
You can find out everything you need to know about
operating your appliance here.
Switching on the appliance
Requirement: Align the remote control as precisely as
possible to the infrared receiver for the LED display.
Press
to switch on the appliance.
▶
a The appliance starts at fan setting 2.
a The LED for the set fan setting lights up in the LED
display.
Switching off the appliance
Switch the appliance off when you are not using it.
1
/fan run-on time/interval vent-
Advertisement
Table of Contents
