Page 1
Gigaset DESK 200 overview Call-indicator flashes on incoming calls Speed dial key Mute key with LED The LED flashes if the micropho- ne is switched off Set key The mute key LED flashes while the telephone is in set mode...
Intended use connector cable handset cable operating instructions Your DESK 200 phone, or phone below, is suitable for making calls If something is missing or damaged, within a phone network. The phone please contact our Customer Service is suited solely to private use in team (page 7).
Connecting the telephone Connect the phone headset to the cradle. Use the short end of the headset cable to connect it to the phone headset (1) and the other end of the handset cradle (2). Plug your phone into the phone connector.
Setting up the telephone Saving number for use Press the set key. Press the speed dial Recommended installation of tele- key. phone: Define the speed dial Do not expose the telephone to number. direct sunlight or other sources Enter the number for of heat.
Adjusting the telephone Changing the dialling mode/ flash time Setting the handset volume The telephone supports the follow- ing dialling modes: The handset volume can be set to T1: Tone dialling, flash time 100 ms two levels. T2: Tone dialling, flash time 270 / Press the handset vol- 600 ms ume control key.
Page 6
Environmental management static. system In rare cases, contact with chemical substances can cause changes to the Gigaset Com- device’s exterior. Due to the wide munications variety of chemical products availa- GmbH is cer- ble on the market, it was not possible tified pursu- to test all substances.
Page 7
UK and on the Irish network. Country-specific requirements have been taken into consideration. We, Gigaset Communications GmbH, declare that this device meets the essential requirements and other rel- evant regulations laid down in Direc- tives 2014/30/EU and 2014/35/EU.
Need help?
Do you have a question about the DESK 200 and is the answer not in the manual?
Questions and answers