Side Shelf Assembly Instructions (Optional) - DCS CAD1 Series Installation Manual/User Manual

Side shelf assembly instructions (optional)

Optional attach side shelf accessory on either side
Note: side shelf model CAD1-SK can be installed with the head already on the cart.
1
2
3
4
Optional wood cutting board (model # CAD1-WCB,
70861) can be purchased as an accessory from
www.fisherpaykel.com
18
INSTALLATION
Shoulder bolt
screw location
Screw two shoulder bolts into the bottom
threaded holes on the side of the cart.
Tighten with 5/32 Allen Key.
Slide shelf brackets over the shoulder bolts
and install top screw, attaching the side-shelf
brackets onto the cart. Tighten with Phillips
screwdriver.
Holding the side shelf, install two shoulder
bolts into the slot and screw into the side
shelf tray. Tighten with a 3/16 Allen key.
Place shelf in the up position and check for
level. If shelf is not level, adjust side shelf set
screw. Set screws can be adjusted using a
3/32 Allen Key. Turn the Allen key clockwise
to raise the shelf. Turn 1/4 turn and review
to see if the shelf is level. The set screws in
the left and right bracket should be adjusted
equally to ensure the shelf sits level.