Calling Another Party; Talking To Another Party; Roger Beep Confirmation Tone; Listening For Another Party - Cobra microTALK FRS 225 Operating Instructions Manual

Operation
Calling

Calling Another Party

Another
To alert another party that you wish to
Party communicate:
Note
Both units must be ON and
tuned to the same channel.
Your incoming "Call" signal
Push and release
1
volume is dependent on the
you are calling will hear a two second ringing
unit volume setting.
tone.

Talking To Another Party

Talking To
Another Party
Note
While the TALK button is
Push and hold
depressed you cannot 1
receive incoming calls. TALK button.
Hold mic about 2 inches
3
from mouth. Speak in a
normal voice.
6
BATT LOW
call
CALL button. The unit
call
BATT LOW
The TX/RX indicator
2
will be displayed.
Release TALK
4
button and listen for
response.

Roger Beep Confirmation Tone

Your listener will hear an
audible tone when you
release the
BATT LOW
This alerts the other party
that you are finished talking
call
and it's OK for them to begin
talking.

Listening For Another Party

When finished talking:
Release TALK button to receive incoming
1
transmissions.
Your microTALK® is always in listening mode
when the TALK button is not pressed.
Adjust volume by turning the On/Off Volume
2
Switch
Operation
Roger Beep
Confirmation
Tone
TALK button.
Listening For
Another Party
Note
While the TALK button is
depressed you cannot
receive incoming calls.
7