Update Trail Criteria; Trail Update Rate; Specific Trail Options; Delete Trail - Lowrance iFINDER Expedition C Operation Instructions Manual

Update Trail Criteria

There are three criteria by which trails may be updated: automatic,
time or distance. When it is in the default automatic mode, the unit
does not update the plot trail while you are traveling in a straight line.
Once you deviate from a straight line, the unit drops a plot point (trail
waypoint) onto the trail. This conserves plot trail points. If a plot trail
uses all of the available points allotted to it, the beginning points are
taken away and placed at the end of the trail.
Update Criteria with Time selected (left). With the setting above, the
trail would update every three seconds. Distance is selected (right). It

Trail Update Rate

You can update a trail by time, with a range from 1 to 9999 seconds.
The default is 3 seconds. You can update by distance, with a range from
0.01 mile/nm/km to 9.99 mile/nm/km. The default is 0.10 mile.
Highlight either
. That will launch a data entry box. Press ↓ to the data entry
press
ENT
box and press
press → to the next character and repeat until the entry is correct.
Press |
EXIT EXIT

Specific Trail Options

Delete Trail

To delete a specific trail from the Trails menu, press ↓ to the list of
saved trails, select a trail and press
as seen in the following figure. Press ↓ to
| .
Y ENT
ES

New Trail

If you want to manually start a new trail from the Trails Menu, high-
light
N T
EW RAIL
trail name listed in the name box at the top.
is set to update the trail every .10 of a mile.
or
T D
IME ISTANCE
. Use the ↑ ↓ keys to change the first character, then
ENT
to return to the Trails Menu.
and press
ENT
from the Update Criteria menu and
. The Edit Trail menu appears
ENT
. The edit trail menu appears with the new
101
|
D T ENT
ELETE RAIL
|← to