Network Checklist - Lorex L15LD420 Series Instruction Manual

Network Checklist

The following checklist is provided to assist you in confirming that all steps have been
successfully performed during Network Setup. Use this checklist in conjunction with the steps
outlined on the following pages.
1. I have the following:
• High Speed Internet
• A Router
• The Ethernet Cable provided with this system
• The System
• A PC with the Remote Access software installed
2. I have confirmed that my System is set to automatically complete my Network settings
(DHCP is set to ON):
• Press the SETUP button on the Front Panel -or- Press SETUP on the Remote -or- Right
Click on the screen and select the SETUP option.
• From the main menu, select the EXTERNAL DEVICE option. Select the TCPIP SETUP
Menu, then choose the IP SETUP Menu.
• Confirm that DHCP Mode is set to AUTOMATIC
3. I have turned off the System, and performed the following:
• Connected the Ethernet Cable to the back of the System
• Connected the other end of the Ethernet Cable to my Router
NOTE: Network Setup will not work if you do not have a router
4. I have found my System Information by navigating through the System Menus (MAIN
MENU / EXTERNAL DEVICE / TCPIP SETUP / IP SETUP):
• My IP Address is: ________________________________
• My MAC Address is: ______________________________
NOTE: If your IP address is showing as 127.0.0.1 or 0.0.0.0 please return to Step 1 and review
all menu settings. Check to make sure that your Ethernet cable is properly connected to your
Router and System.
Appendix #1 - Setting up Remote Viewing
23