Appendix #1 - Setting Up Remote Viewing; What Do You Need; Network Setup / Remote Access Overview - Lorex L15LD420 Series Instruction Manual

Appendix #1 - Setting up Remote Viewing

Appendix #1 - Setting up Remote Viewing
Setting up the Remote Viewing Feature requires several steps. Networking skills are required to
correctly configure the remote viewing functions.

What do you need?

• The LCD/DVR System.
• A PC with the installed with the Lorex Client 2.2 Integrated Remote Agent Software
• A Router (not provided with the system) and High Speed Cable or DSL Internet Connectivity
(for remote viewing outside your network)

Network Setup / Remote Access Overview

The System can be remotely controlled using your existing network and the Lorex Client 2.2 soft-
ware or Internet Explorer.
1. Connect the System to the Router using the supplied Ethernet Cable. Power the System on.
The System must be connected to the router prior to powering on the system. This allows the
system to communicate on your network
INTERNET
2. Find the IP address of your System through the Menu System on the unit.
3. Enable PORT FORWARDING on your Router. Refer to the included Router Guide and Basics
of Remote Video Access Guide for further assistance with your specific network setup and
hardware.
4. Set up a web account at http://www.lorexddns.net.
5. Setup the System DDNS.
6. Configure the software, using the information gathered on the following pages.
22
SYSTEM
ROUTER
(Not Included)
PC
(Not Included)