Table of Contents
Advertisement
6 Installation instructions
Installation instructions
• Have the installer show you the location of the gas shut off
valve and how to shut it off in emergency.
• Be certain all packing materials are removed from the
hob before operating to prevent fire or smoke damage
that could be caused by the presence of these materials.
• Observe all instructions for minimum clearance to any
combustible surfaces. These should be in accordance with
information on the rating plate and with national fire laws.
• If the hob is installed near windows, proper precautions
should be taken to prevent curtains from blowing over
burners creating FIRE HAZARD.
• When choosing a location for this hob consider, availability
and position of gas and electric supply paths.
• Any openings around gas and electric service outlets shall be
closed at the time of installation.
• Do not install another hob next to this unit.
• The underside of the hob must be checked to ensure that
there are no projections which might foul the hob. Make sure
that the countertop is solidly supported and can withstand the
weight of the hob.
• Check that the cabinet is leveled from side to side and from
front to back in its installed position.
• Cabinet ventilation can be improved by the provision of air
holes to the cabinet. Care should be taken to ensure that
ventilation holes are not obstructed.
• When fitting a vent hood above the hob, refer to the
manufacturer own installations relating to that product.
However as a general rule, a minimum clear vertical distance
of 750mm (30" should be maintained between the cooktop
and the underside of any cupboard, wall unit or vent. (Fig 6)
• Any cabinet installed above the cooktop must not be greater
than 325mm (13" deep. (Fig 6)
• The edge of the hob must have a minimum distance from the
real wall of 55mm. (Fig 6)
BATTERY COMPARTMENT
1. When the battery is exhausted; or the spark become
weakness, a new battery should be replaced.
2.
The battery compartment is located as shown in the
diagram. Please place the battery in correct polarity as
shown.
Warning: Please take out the battery if not use for a long
time.
min.
750mm
If clearance between side/back walls and periphery of the burner is
less than 200mm, the walls must be protected with a
non-combustible material. The protection must extend a minimum
distance of 450mm above the burner. Horizontal surfaces less than
750mm vertically above the cooktop must also be protected.
Advertisement
Table of Contents
